How to install the wire end cap is standard?

How to install the wire end cap is standard?

  • Post author:
  • Post category:News
  • Post last modified:April 30, 2021

Today, I will introduce to you the whole process of disassembly and assembly of the wire end cap of the oil pump motor, as well as some precautions for the wire end cap.

(1) Loosen the bolts of the bearing cover first, and remove the bearing cover. In order to facilitate resetting during assembly, mark any position of the joint between the end cover and the machine base, loosen the fastening bolts of the end cover, and then evenly strike the periphery of the end cover with a hand hammer (lined with pads when beating) Wood), remove the wire end cap.

(2) Before installing the front end cover of the oil pump motor, check the end cover again. The stator stop should be clean and free of ash and burrs. The rotor stop should also be clean and free of ash and burrs. Otherwise, it should be cleaned. Align the front end cover with the mark of the machine base, and evenly knock around the end cover with a wooden hammer to make the end cover enter the stop, and then screw on the fastening bolts of the end cover. Finally, tighten the bolts of the front and rear cover evenly on the diagonal, up and down, left and right. In the process of tightening the bolts, the rotor should be turned while tightening to avoid the rotor being out of center or jamming. Removal and installation method of wire end cap.